Epson SpectroProofer Setup And Maintenance page 24

24 | Maintenance and Problem Solving
Message
SpectroProofer Error
Error No. 13
SpectroProofer Error
Error No. 15
SpectroProofer Error
Error No. 80
SpectroProofer Error
Error No. 12, 14, D5, D6, 65
Note:
If you see an error
message that isn't listed,
contact Epson as
described on page 25.
Explanation
The paper presser is not
working correctly because:
•
The backing plate is not
attached correctly.
•
There is something between
the backing plate and the
presser.
•
The environmental
conditions are not correct.
The carriage is not working
correctly because:
•
There is something blocking
the carriage.
•
The backing plate is not
attached correctly.
•
The white calibration tile
holder is not installed
correctly.
•
The environmental
conditions are not correct.
The SpectroProofer is not
calibrated correctly.
24
Solution
Turn the printer off, then remove the
SpectroProofer. Check for any loose or
obstructing packing materials.
Make sure the backing plate is installed
correctly. Reinstall the SpectroProofer and
turn the printer back on.
Make sure your operating environment
meets the specifications (see page 26).
If the error appears again, contact Epson as
described on page 25.
Turn the printer off, then remove the
SpectroProofer. Check for any loose or
obstructing packing materials.
Make sure the backing plate and the white
tile holder are attached correctly. Reinstall
the SpectroProofer and turn the printer back
on.
Make sure your operating environment
meets the specifications (see page 26).
If the error appears again, contact Epson as
described on page 25.
Remove the SpectroProofer and check the
spectrophotometer and the label of the
calibration tile. If you have multiple
spectrophotometer units, make sure you
install the unit that matches the number on
the calibration tile.
Clean the lens of the spectrophotometer
(see page 19).
Note the error number and contact Epson as
described on page 25.