Epson SpectroProofer Setup And Maintenance page 9

Note:
The backing plates provide
a uniformly opaque surface
under the paper. Use the
white backing plate for
most papers. Use the black
backing plate if your paper
has low opacity and a
watermark on the reverse
side.
3. Using the included bolts and hex wrench, install the mounting rails in
the two locations shown below.
4. Select whether you want to use the white or black backing plate(s).
To attach a plate, align the tabs at the top of the plate with the slots on
the printer, and then release the plate so it rests flush against the printer.
The backing plate adheres magnetically; it is attached correctly if it
doesn't move when you try to slide it.
Setting Up the SpectroProofer
9
| 9