Interposer module
Removing the interposer module
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
top cover (side bezel)
4. Remove the
front
bezel.
5. Remove the
fan
assembly.
NOTE:
This step is valid for system configuration that is shipped with 80 W CPU.
6. Remove the
riser
card.
About this task
The following images indicate the location of the interposer module and provide a visual representation of the removal
procedure.
Steps
1. Flip open the actuator and disconnect the SATA FPC cable from the system board.
2. Loosen and remove the single screw (M3x5) securing the interposer module to the system board.
Installing the interposer module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
before working inside your
computer.
Disassembly and reassembly
63