7. Remove the
solid-state
8. Remove the
WLAN
card.
9. Remove the speaker.
10. Remove the
fan
assembly.
11. Remove the
memory
modules.
12. Remove the
riser
card.
13. Remove the
heat
sink.
14. Remove the
interposer
15. Remove the
system
board.
About this task
The following images indicate the location of the internal antenna and provide a visual representation of the removal procedure.
Steps
1. Pry the metallic routing tabs and unroute the antenna cables from the chassis.
2. Loosen and remove the single screw (M3x3) securing the internal antenna to the chassis.
Installing the Internal antenna
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
80
Disassembly and reassembly
drive.
module.