Installation and Setup
5. In the Configure Member – RAID Configuration dialog box (Figure 3-5), do
the following and then click
•
Select the RAID policy. You will not be able to select a RAID policy that
is not supported by the array model.
•
Optionally, to delay using the member's storage space until the RAID
verification completes and the batteries are fully charged, select
until the member storage initialization completes
default, the space is immediately available, although performance will not
be optimal until the RAID verification completes.
Figure 3-5: Configure Member – RAID Configuration
6. In the Configure Member – Summary dialog box (Figure 3-6), click
if the member configuration is satisfactory. Click
3–10
.
Next
Configuring the Software
to make changes.
Back
Wait
. By
Finish