Toro CM Series Operator's Manual page 11

2
Installing the Tongue
End-Dump Models Only
Parts needed for this procedure:
1 Tongue
1 Front stabilizer leg
6 Short bolt
1 Long bolt
7 Nut
Installing the Tongue to the Machine
1. Lower the rear stabilizer legs; refer to
Stabilizer Legs (page
2. Place jack stands under the front frame rail to prevent
the machine from tipping forward
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious injury.
Use jack stands when supporting the machine.
1
1. Support points
3. Remove the 2 nuts and bolts that secure the front
stabilizer leg to the frame
front stabilizer leg.
Lowering the
21).
(Figure 5).
G021091
Figure 5
(Figure 6) and remove the
1
1. Front stabilizer leg
4. Install the tongue into the opening at the front of
the machine and secure it with 6 nuts and short bolts
torqued to 102 N∙m (75 ft-lb); refer to
1 2 3
6
1. Clevis pin
2. Long bolt
3. Short bolt (6)
5. Align the top rear hole in the front stabilizer leg to the
hole past the handle in the front of the tongue
7).
6. Install the long bolt through the holes and secure it with
a nut torqued to 102 N∙m (75 ft-lb); refer to
Note: The stabilizer leg pivots rearward on the bolt.
If you install the bolt into the wrong hole, the stabilizer
leg will not work properly.
7. Insert the clevis pin to lock the front stabilizer leg in
position (Figure
11
Figure 6
Figure
5 4
Figure 7
4. Nut (7)
5. Tongue
6. Front stabilizer leg
7).
G021092
7.
G021093
(Figure
Figure 7.