Opening And Closing The Cowl; Adding Fuel - Toro CM Series Operator's Manual

Figure 30
1. Remove the clevis pin.
2. Rotate the stabilizer leg
down.
7. Rotate the front stabilizer leg down toward the ground
(Figure 30).
8. Push the clevis pin through the front hole in the tongue
and the front stabilizer leg
lower the machine to the ground.

Opening and Closing the Cowl

Opening the Cowl
Figure 31
1
2
3
G019916
3. Install the clevis pin.
(Figure 30) and carefully
Closing the Cowl

Adding Fuel

•
For best results, use only clean, fresh (less than 30 days
old), unleaded gasoline with an octane rating of 87 or
higher ((R+M)/2 rating method).
•
Ethanol: Gasoline with up to 10% ethanol (gasohol)
or 15% MTBE (methyl tertiary butyl ether) by volume
is acceptable. Ethanol and MTBE are not the same.
Gasoline with 15% ethanol (E15) by volume is not
approved for use. Never use gasoline that contains
more than 10% ethanol by volume, such as E15
(contains 15% ethanol), E20 (contains 20% ethanol), or
E85 (contains up to 85% ethanol). Using unapproved
gasoline may cause performance problems and/or engine
damage which may not be covered under warranty.
•
Do not use gasoline containing methanol.
•
Do not store fuel either in the fuel tank or fuel containers
over the winter unless you use a fuel stabilizer.
•
Do not add oil to gasoline.
22
Figure 32