Toshiba NV Series Hardware Manual page 106

■ Procedure to mount modules to base unit BUM7B
(1) Mount base unit BUM7B to the vertical plane of the control panel (refer to "3.5 Mounting
Base Unit").
(2) Check the mounting slot on the base unit for each module.
● On the main base unit:
• Power supply connector cover (attached to BUM7B): Leftmost slot
• type1 light controller module (PUM12): Slot S0
• G2 I/O module: Any slot from S1 to S10
• Space module (SP600): Any slot from S1 to S11 without containing G2 I/O
● On the remote base unit:
• Power supply connector cover (attached to BUM7B): Leftmost slot
• TC-net I/O loop G2 I/O adapter module (GA922): Slot S0
• G2 I/O module: Any slot from S1 to S11
• Space module (SP600): Any slot from S1 to S11 without containing G2 I/O
(3) Align the module to the top and bottom slot
guides on the base unit.
(4) Hold the module firmly and slowly push it
straight into the slot.
Make sure the top and bottom lock levers are
set on the base unit and a clicking sound is
heard.
Unified Controller nv Series type1 light Controller Unit Operating Instructions
87