A.2 Outline Drawing - Toshiba NV Series Hardware Manual

A.2 Outline Drawing

The external views of base unit BUM7B dedicated to the migration system are shown
below.
External dimensions
Left side view
左側面
Power connector cover
Power input terminal block
Be sure to mount the terminal block signal conversion adapter or attached blank panel
on slots S1, S6 and S11.
BUM7B may deform or break if it is transported, installed or operated without anything
inserted in these slots.
When handling BUM7B, wear protective gloves to prevent injury caused by the metal
frame edge or sharp parts of BUM7B.
Top view
G2 I/O module mounting hole x 11
Front view
LED (POWER)
Terminal block signal conversion adapter
(Top bracket (11) + Bottom bracket (11))
Figure A.2 External dimension of BUM7B
Unified Controller nv Series type1 light Controller Unit Operating Instructions
Top bracket
480mm
465mm
Blanc panel
Bottom bracket
mounting hole
A
Mounting hole x 4
123