Table of Contents
Advertisement
2 NAMES AND FUNCTIONS OF EACH PART
2.1 Names and Functions of Each Part
①
LQE521
②
TX
RX
ERR
③
10BASE
-5
10BASE
-T
12V
GND
FG
Switch off the power supply before operating the module number setting switch.
If you operate while the power supply is applied, it may result in a malfunction.
No.
①
②
④
SV.LINK
③
MODU
No.
④
⑤
⑥
⑦
⑤
⑥
⑧
⑦
⑧
Name
TX LED
Lights during data transfer.
Lights when data flows on the transmission line
RX LED
(when a carrier is detected).
Lights when a hardware error or user setup
ERR LED
parameter error is detected.
Module
Specifies the main module or submodule and also
number setting
sets a communication port type. The setting of
switch
this switch becomes effective when resetting of
the computer system is completed.
Module No.
Main
0
2
4
6
8
A
C
E
10BASE-5
Connects to Mitsubishi's MELSEC sequencer or
connector
motion controller.
10BASE-T
Connects to Mitsubishi's MELSEC sequencer or
connector
motion controller.
Power input
Connects with the power supply (12 VDC) for a
terminal
transceiver which is connected with 10BASE-5.
Connected to the shield line of the transceiver
Frame ground
cable.
NOTICE
2-2
Function
Description
Sub
1
Communication using
10BASE-5 connections
3
Communication using
10BASE-T connections
5
Setting is disabled.
7
Setting is disabled.
9
Setting is disabled.
B
Setting is disabled.
D
Setting is disabled.
F
Setting is disabled.
Advertisement
Table of Contents
