Voip; Overview - Huawei B2368 Series User Manual

LTE CPE B2368 User's
Guide

15.1 Overview

The information in this section allows you to:
•
•
•
•
•
Issue 01
LTE modem to connect to analog phone.
Make phone calls over the Internet and conventional telephone network.
Perform speed-dial settings.
Optimize the sound quality of phone calls.
If several APN is required to perform the following steps to ensure that the device or Softphone IAD on
the LAN are routed to the correct path (ie. The second APN).
Add a static route that directs traffic on the media server (eg.
204.11.12.32 the diagram at right) through the interface Voice in settings Network Settings> Static 204.11.12.32 the diagram at right) through the interface Voice in settings Network Settings> Static 204.11.12.32 the diagram at right) through the interface Voice in settings Network Settings> Static 204.11.12.32 the diagram at right) through the interface Voice in settings Network Settings> Static 204.11.12.32 the diagram at right) through the interface Voice in settings Network Settings> Static
Routing> Add new static routing ( more information, see chapter 7.2.1 Add / Edit static routing). After Routing> Add new static routing ( more information, see chapter 7.2.1 Add / Edit static routing). After
adding a new rule of static routing wait until the timeout interval repetition registration and VoIP will not
automatically connect to the server. You can also go to the screen system monitor and register the VoIP automatically connect to the server. You can also go to the screen system monitor and register the VoIP automatically connect to the server. You can also go to the screen system monitor and register the VoIP
server manually.
Figure 15-1 Static routing via Voice Figure 15-1 Static routing via Voice
Copyright © Huawei Technologies Co., Ltd.
15 15

VoIP

VoIP
15 VoIP
106