Huawei B2368 Series User Manual page 32

LTE CPE B2368 User's
Guide
Figure 4-2 Network Settings> Broadband> Broadband> Edit Figure 4-2 Network Settings> Broadband> Broadband> Edit
The following table summarizes the available fields on this screen.
Table 4-2 Network Settings> Broadband> Broadband> Edit Table 4-2 Network Settings> Broadband> Broadband> Edit
Item
Name
Auto APN
APN
MTU
enable NAT
IP Pass Through Check this box to allow access providers assign IP
The IP Pass
Through
Issue 01
Description
Name respective broadband.
Check this box to turn on automatic detection of the access point name APN of the
LTE network. Otherwise, enter the APN manually in the field below.
Enter the name APN LTE network. Name, contact your ISP.
The maximum size of the transmission unit (MTU) defines the largest possible
packet size on the interface or connection. Enter the MTU value for the appropriate
WAN interface.
Check to NAT routing for the WAN interface.
directly addresses devices on the LAN. This setting disables possibly setting NAT and
DHCP server configuration ( Network Settings> Home Network> LAN Settings). LTE DHCP server configuration ( Network Settings> Home Network> LAN Settings). LTE DHCP server configuration ( Network Settings> Home Network> LAN Settings). LTE
modem will be managed remotely via HTTPS and SNMP. Checking this item will also
receive additional parameters setting IP Pass Through.
Select Dynamic to assign IP addresses ISP via DHCP leases 5 minutes. Select Static Select Dynamic to assign IP addresses ISP via DHCP leases 5 minutes. Select Static Select Dynamic to assign IP addresses ISP via DHCP leases 5 minutes. Select Static Select Dynamic to assign IP addresses ISP via DHCP leases 5 minutes. Select Static
for assigning IP addresses via DHCP ISP only devices with specific MAC
Copyright © Huawei Technologies Co., Ltd.
4 Broadband
29