Advertisement
Figure 12
1. Route the wire harness here.
8. Plug the wireless-control-base lead into the harness
adapter that was previously disconnected from the
wireless-control base
Note: Ensure that you connect the leads into the
proper connector color and internal notches.
Figure 13
1. Harness-adapter
lead to the wireless
TEC-controller-harness
lead
2. Harness-adapter
lead to the
wired-controller-harness
lead
(Figure 13
and
Figure
14).
3. Harness-adapter
lead to the
wired-controller-harness
lead
4. Harness-adapter
lead to the wireless
TEC-controller-harness
lead
1. Wire-harness adapter
2. Connect this wire-harness
lead to the wire-harness
adapter.
3. Wireless
TEC-controller-wire
harness
4. Wireless TEC contoller
9. Plug the harness-adapter lead into the
wired-controller-harness lead
Figure
14).
10. Plug the yellow wire from wired-controller harness into
the yellow wire located by the hour meter
and
Figure
14).
Note: You will need to cut the plastic cover off the
yellow-wire connector on the harness.
11. Install the battery.
12. Connect the positive-battery cable first, and then
connect the negative-battery cable.
6
Figure 14
5. Yellow wire located by the
hour meter
6. Plastic cover
7. Wired controller
8. Yellow wire from the
wired-controller harness
(Figure 13
and
(Figure 13
Advertisement
