Processing method of the cable terminal
Strip the cable from the tip to connect a bar solderless terminal at the stripped area. For how long the cable should be
stripped, follow the specifications of the bar solderless terminal used. Stripping the cable too long may cause electric shock or
short circuit between adjacent terminals because the conductive part sticks out of the terminal block. Stripping the cable too
short may cause a poor contact to the spring clamp terminal part.
Wiring method and installation/removal procedures of the cables and connectors
For the wiring method, installation procedure, and removal procedure, refer to the following.
MELSEC iQ-R Module Configuration Manual
6
6 INSTALLATION AND WIRING
107
6.2 Wiring