Example For Measuring A Workpiece In Automatic - Siemens SINUMERIK 828D Manual

General information on workpiece production

2.8.3 Example for measuring a workpiece in AUTOMATIC

The procedure is illustrated on the basis of the Measure pocket function. The cycle
automatically measures the right-angled pocket and enters the values in the zero offset.
Requirements for using cycles
The probe is calibrated and active; the tool compensation is activated.
Determining zero offset via Measure right-angled pocket:
Create a new program for measuring the workpiece or edit an existing one.
In the expanded softkey bar, select the Measure workpiece > Hole > Right-angled pocket
softkeys.
Select the tool (3D probe), specify the measuring technique and enter the starting point of the
measurement. .
1
You can define whether the result of the measurement should be a compensation or merely a
measuring process .
2
Compensation in the zero offset with specification of the zero offset
Compensation in the tool compensation data
Measurement only
As you are setting up the workpiece here, the compensation is made in the zero offset.
Enter the setpoints of the right-angled pocket and parameterize additional cycle parameters
.
3
After the measurement, the measured values are compensated in the active zero offset
frame.
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling
1
2
3
2.8
53