Technology G Groups - Siemens SINUMERIK 828D Manual

3.7
118
Important functions for 3- to 5-axis machining
ORISON programming (without CYCLE832)
N110 TRAORI
N120 CYCLE832(0.005,1,1)
N130 ORISON
N140 OTOL=0.5
N150 G1 X10 A3=1 B3=0 C3=1
...
N990 ORISOF
ORISON programming (with CYCLE832)
N110 TRAORI
N120 CYCLE832(0.005,_ORI_FINISH,0.5)
N130 ORISON
N140 G1 X10 A3=1 B3=0 C3=1
...
N990 M30

3.7.7 Technology G groups

Using the "Technology" G group, the appropriate dynamic response can be activated on the
machine for 5 varying technological machining operations. The dynamic values and G codes are
configured and set by the machine manufacturer.
Five dynamic response settings are available in the Technology G code group:
DYNORM for standard dynamic response
DYNPOS for positioning mode, tapping
DYNROUGH for roughing
DYNSEMIFIN for semi-finishing
DYNFINISH for finishing
The G groups are switched and activated automatically when the machining method (e.g.
finishing or roughing with CYCLE832 or CUST_832) is selected.
Dynamic parameters can be adapted to the respective machining operation with the technology
G groups. Using the commands of technology G group 59, the value of channel and axis-specific
machine data is activated using the corresponding array index. These are, for example, jerk and
acceleration values.
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling
; Activation of orientation transformation.
; Activation of orientation smoothing
; Specify tolerance
; Geometry program
; Deactivation of orientation smoothing
; Activation of orientation transformation.
; Activation of the orientation smoothing
; Geometry program
; End of program