Technology G Groups (Dynnorm, Dynpos, Dynrough, Dynsemifin, Dynfish) - Siemens SINUMERIK 840DE Programming Manual

5.4.3 Technology G groups (DYNNORM, DYNPOS, DYNROUGH, DYNSEMIFIN,
DYNFISH)
Function
Using the "Technology" G group, the appropriate dynamic response can be activated for five
varying technological machining steps.
Machine manufacturer
Dynamic values and G codes can be configured and are, therefore, dependent on machine
data settings.
References: /FB3/, B1, "Continuous-path mode"
Programming
DYNNORM
Or
DYNPOS
Or
DYNROUGH
Or
DYNSEMIFIN
Or
DYNFINISH
Parameters
DYNNORM
DYNPOS
DYNROUGH
DYNSEMIFIN
DYNFINISH
Write or read specific field element
$MA...[n, X]
[<n>, <X>]
n = 0 to 4
Note
The dynamic values are already active in the block, in which the associated G code is
programmed. Machining is not stopped.
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
Standard dynamic response, as previously (index n=0)
Dynamic response for positioning mode, tapping (index n=1)
Dynamic response for roughing (index n=2)
Dynamic response for finishing (index n=3)
Dynamic response for smooth-finishing (index n=4)
Machine data with field element, which affects dynamic
response
Field element with field device n and axis address X
Range of values corresponds to Technology G group.
Path Action
5.4 Acceleration behavior
5-19