Siemens SINUMERIK 840DE Programming Manual page 87

Hide thumbs Also See for SINUMERIK 840DE:

Table of Contents

N10 G0 G90 X20 Y30 Z2 S2000 M3 T1

N20 G1 Z-5 F500

N40 G70 X2.75 Y3.22

N50 X1.18 Y3.54

N60 G71 X 20 Y30

N70 G0 Z2 M30

You can instruct the control to convert the following geometrical dimensions (with necessary

deviations) into the system of units not set and enter them directly:

• Positional data X, Y, Z, ...

• Intermediate point coordinates I1, J1, K1

• Thread lead (G34, G35)

• Programmable zero offset (TRANS)

• Polar radius RP

Fundamentals

Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1

Interpolation parameters I, J, K and circle radius

CR in circle programming

3.4 Dimensions inch/metric, (G70/G700, G71/G710)

;Basic setting metric

;At feedrate in Z [mm/min]

;Enter destination positions in inches,

;is active until deselected by G71 or

;end of program

;Enter positions in mm

;Retract in rapid traverse, end of

Positional Data

Show Quick Links

Table of Contents