Siemens SINUMERIK 840DE Programming Manual page 341

Example
• Smooth approach (block N20 activated)
• Approach motion with quadrant (G247)
• Approach direction not programmed, G140 is operative, i.e., TRC is active (G41)
• Contour offset OFFN=5 (N10)
• Current tool radius=10; thus the effective offset radius for TRC=15, the radius of the SAR
• The end point of the circle is obtained from N30, since only the Z position is programmed
• Infeed movement
• Smooth retraction (block N60 active)
• Retraction motion with quadrant (G248) and helix (G340)
• FAD not programmed, since irrelevant for G340
• Z=2 in the start point; Z=8 in the end point, since DISCL=6
• When DISR=5, the radius of SAR contour=20; that of the tool center point path=5
Retraction motions from Z8 to Z20 and the motion parallel to X-Y plane to X70 Y0
$TC_DP1[1.1]= 120
$TC_DP6[1.1]=10
N10 G0 X0 Y0 Z20 G64 D1 T1 OFFN
= 5
N20 G41 G247 G341 Z0
DISCL = AC(7) DISR = 10 F1500
FAD=200
N30 G1 X30 Y-10
N40 X40 Z2
N50 X50
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
contour=25, so that the radius of the tool center point path is then DISR=10.
in N20
– From Z20 to Z7 (DISCL=AC(7)) with rapid traverse
– Then on to Z0 with FAD=200
– Approach circle in X-Y plane and following blocks with F1500 (in order for this speed
to become active in the following blocks, the G0 active in N30 must be overwritten by
G1, otherwise the contour would continue to be machined with G0)
8.11 Smooth approach and retraction
;Tool definition T1/D1
;Radius
;(P )
0app
;Approach (P )
3app
;(P )
4app
;(P )
4ret
Tool offsets
8-45