Delete Additive Offsets (Deldl) - Siemens SINUMERIK 840DE Programming Manual

Tool offsets
8.16 Additive offsets
Programming
$TC_SCPxy[t,d] wear values
Or
$TC_ECPxy[t,d] setup values
Parameters
$TC_SCPxy
$TC_ECPxy
t
d
Note
The defined wear and setup values are added to the geometry parameters and the other
offset parameters (D numbers).
Example
The wear value of length 1 is set to the value 1.0 for the tool edge (D number d) of the tool
(t).
Parameter: $TC_DP3 (length 1, with turning tools)
Wear values: $TC_SCP13 to $TC_SCP63
Setup values: $TC_ECP13 to $TC_ECP63
$TC_SCP43 [t, d] = 1.0
8.16.3

Delete additive offsets (DELDL)

Function
DELDL is used to delete the additive offsets for the tool edge of a tool (in order to release
memory). Both the defined wear values and the setup values are deleted.
8-70
Wear values are assigned to the corresponding geometry
parameters via xy, where x is the number of the wear value
and y is the reference to the geometry parameter.
Setup values are assigned to the corresponding geometry
parameters via xy, where x is the number of the setup
value and y is the reference to the geometry parameter.
T number of the tool
D number of the tool edge
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
Fundamentals