Siemens SINUMERIK 840DE Programming Manual page 103

Programming
G25 X...Y...Z... Programming in a separate NC block
Or
G26 X...Y...Z... Programming in a separate NC block
Or
WALIMON
Or
WALIMOF
Parameters
G25, X Y Z
G26, X Y Z
WALIMON
WALIMOF
Note
G25/G26 can also be used to program limits for spindle speeds at the address S. For further
information, please refer to "Feed control and spindle motion".
In addition to programming values using G25/G26, you can also parameterize them in
setting data.
The axial setting data define the axes, for which the working area limitation is valid.
Example of turning
A protection zone is defined in the working area of a turning machine. This protects the
surrounding equipment such as turrets, measuring stations, etc., against damage.
Default setting: WALIMON
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
3.8 Working area limitation (G25/G26, WALIMON, WALIMOF)
Lower working area limitation, value assignment in the
channel axes in the basic coordinate system
Upper working area limitation, value assignment in the
channel axes in the basic coordinate system
Switch on working area limitation for all axes
Working area limitation switch-off for all axes
Positional Data
3-29