Tables; List Of Statements - Siemens SINUMERIK 840DE Programming Manual

Tables

12.1

List of statements

List of statements
The list of instructions summarizes all basic programming commands.
Legend:
Default setting at beginning of program (factory settings of the control, if nothing else programmed).
1
The groups are numbered according to the table in section "List of G functions/preparatory functions"
2
Absolute end points: modal; incremental end points: non-modal; otherwise modal/non-modal (m, n), depending on syntax
3
of G function.
As arc centers, IPO parameters act incrementally. They can be programmed in absolute mode with AC. The address
4
modification is ignored when the parameters have other meanings (e.g., thread pitch).
The vocabulary word is not valid for SINUMERIK 810D
5
The vocabulary word is not valid for SINUMERIK 810D/NCU571
6
The vocabulary word is only valid for SINUMERIK FM-NC
7
The OEM can add two extra interpolation types. The names can be changed by the OEM.
8
Extended address notation cannot be used for these functions.
9
Name Meaning
: Block number - main block (see N)
Fundamentals
Programming Manual, 10.2004 Edition, 6FC5 298-7AB00-0BP1
Value Description,
assignme comment
nt
0 ... special
9999 identification of
9999 blocks, instead
integers of N... ;this block
only, should contain
without all instructions
leading required for a
signs complete
subsequent
machining
section
Syntax
e.g.,20
12
Mod Group
al/
2
non-
mod
al
12-1