GE DMS Go Operator's Manual page 61

2.3.2f Setting the Velocity Reference Block Configuration (CONFIG-VEL. REF. BLOCK) (cont.)
In the MAIN menu, scroll to the CONFIG submenu using the joystick (
1.
2. Use the joystick (
3. Move the joystick to change the unit measurement (inches or mm), the serial number, the velocity of the base material (in inches or
 sec)
mm/ and the coating velocity (the velocity of the coated material, in inches or mm/
Press F2 (DONE) to confirm the entry, or F1 (EXIT) to close the window without changing the configuration.
4. After making your choice, use the joystick (
DMS Go Operator's Manual
Your Complete Source for
Testing Equipment. Since 1969!
) to select the VEL. REF. BLOCK function, and to open the configuration window (Figure 13 below).
Figure 13: Velocity Reference Block Configuration Window
) to move to another function, or press HOME to return to the Main Menu.
www.BergEng.com
Berg Engineering & Sales Company, Inc.
).
 sec
) to the value engraved on the block.
Chapter 2. Instrument Setup
39
1-847-577-3980
Info@BergEng.com