Sharp WH-T36E Service Manual page 12

1. Remove the body in accordance with "REMOVE OF BODY".
2. Disconnect Reed SW. lead wires from the PCB-A
3. Remove 2 screws holding the Reed SW. from the body valve.
4. Now the Reed SW. is free.
Body valve
REMOVE OF BODY VALVE ASS'Y AND WATER OUTLET
1. Remove the body in accordance with "REMOVE OF BODY".
2. Remove the push SW. ass'y in accordance with "REMOVE OF PUSH SWITCH ASS'Y".
3. Remove the reed SW. in accordance with "REMOVE OF REED SWITCH".
4. Detach 2 clamping springs holding the heater tank ass'y with the body valve ass'y and the water outlet.
5. Remove 2 screws holding the body valve ass'y.
6. Remove 2 screws holding the water outlet.
7. Now the body valve ass'y and the water outlet are free.
Clamping spring
Screw
Water outlet
Screw
Body valve ass'y
REMOVE OF REED SWITCH
Screw
Reed SW.
Fig. 24
Fig. 25
12
Reed SW. lead wire
Heater tank
Back cover