Sharp WH-T36E Service Manual page 14

1. Remove the body in accordance with "REMOVE OF BODY".
2. Detach the lead wire for PCB-A CN2 from the PCB-B
3. Pry the claws of volume SW. support-E and remove the PCB-B
4. Remove the nut holding the volume SW. angle with the volume SW. support-E.
5. Remove 2 screws holding volume SW. support-E with the back cover.
6. Pull out the lead wire from the PCB-A
7. Now the volume SW. ass'y is free.
L-Wire for PCB-A CN2
Back cover
Note : For disassembly
Pull the lead wire from PCB-A.
REMOVE OF VOLUME SW. ASS'Y
Volume SW. angle
Volume SW. ass'y
Volume SW.
White lead wire
Green lead wire
Orange lead wire
Nut
PCB-B
Screw
Volume SW. support-E
L-Wire volume SW.
Fig. 28
Blue lead wire
Fig. 29
14