Available Sinumerik Archive Types - Siemens SINUMERIK 840D sl Configuration Manual

3.6.2

Available SINUMERIK archive types

There are different types of archives which you can create in different ways. Essentially, you
cannot use the TIA Portal to create archives that contain NC, drive or HMI data. However, you
can save a finely granular selection of translated program blocks as an archive in the TIA Portal
with the "PLC reload archive".
Archive type
NCU commissioning ar‐
chive
PLC commissioning ar‐
chive (Page 50)
PLC hardware upgrade
archive (Page 48)
PLC reload archive
(Page 52)
Complete archive
Original status archive
SINUMERIK STEP 7 Toolbox V15.1
Configuration Manual, 12/2018, A5E46279635B AA
Command in the TIA Command in SINU‐
Portal MERIK Operate
- Softkey "Commission‐
ing archive", option but‐
ton "Create commis‐
sioning archive"
Hardware and all pro‐ Softkey "Commission‐
gram blocks... ing archive", option but‐
ton "Create commis‐
sioning archive"; only
enable "PLC data" in
the dialog
Only hardware... Softkey "Commission‐
ing archive", option but‐
ton "Create PLC hard‐
ware upgrade archive
(only SDBs)"
Selected program -
blocks...
- <Ctrl> + <Alt> + S
- Softkey "Commission‐
ing archive", option but‐
ton "Create archive
original status"
Configuring the NCU
3.6 Creating SINUMERIK PLC archives
Data contained
The contained data can be configured as fol‐
lows in the dialog:
● NC data
– With or without compensation data
– With or without compile cycles
● PLC data (all or none)
● Drive data (ACX format or ASCII format)
● HMI data (all HMI data or a configurable
selection)
● Hardware data (SDB) of the PLC
● Program blocks of the PLC
● Hardware data (SDB) of the CP
● Hardware data (SDB) of the PLC
● Hardware data (SDB) of the CP
● Program blocks of the PLC
(configurable in the dialog)
All data (not configurable)
Original status (factory setting) of all subcom‐
ponents or a selection of specific subcompo‐
nents and data (configurable in the dialog)
47