4.2
Opening the PLC basic program system library
Procedure
Proceed as follows to open and display the system library of the PLC basic program:
1. Switch to the "Libraries" task card.
2. Select the PLC basic program that matches the firmware version of the inserted NCU:
– SINUMERIK 840D sl PLC basic program V4.5.x.x
– SINUMERIK 840D sl PLC basic program V4.7.x.x
– SINUMERIK 840D sl PLC basic program V4.8.x.x
Result
The system library of the PLC basic program has been opened. Information on handling can be
found under Using copy templates (Page 58) and Adding the PLC basic program (Page 70).
Further information
The block descriptions and other information about the PLC basic program are contained in the
P3 section of the SINUMERIK 840D sl Basic Functions Manual. Basic PLC program.
SINUMERIK STEP 7 Toolbox V15.1
Configuration Manual, 12/2018, A5E46279635B AA
4.2 Opening the PLC basic program system library
Programming the PLC
69