Mitsubishi Electric 800 Series Instruction Manual page 15

• E: The output specification for monitoring and the rated frequency are shown for the standard model, and the
communication protocol group is shown for the Ethernet model and the safety communication model.
Symbol
-1 Pulse (terminal FM)
-4 Voltage (terminal AM)
-5 Voltage (terminal AM)
Protocol group A (CC-Link IE TSN, CC-Link IE Field Network Basic, MODBUS/
PA
TCP, EtherNet/IP, and BACnet/IP)
Protocol group B (CC-Link IE TSN, CC-Link IE Field Network Basic, MODBUS/
PB
TCP, PROFINET)
• F: Availability of circuit board coating / plated conductors is shown.
Symbol
None Without coating
-60 With coating
*1 Conforming to IEC 60721-3-3 3C2
NOTE
• In this Instruction Manual, the inverter model name consists of the inverter rated current and the applicable motor capacity.
(Example) FR-E820-0008(0.1K)
 Accessory
• Fan cover fixing screws
These screws are necessary for compliance with the EU Directives. For details, refer to the document enclosed with the
product.
Capacity
FR-E820-0080(1.5K) to FR-E820-0330(7.5K),
FR-E840-0016(0.4K) to FR-E840-0170(7.5K),
FR-E820S-0080(1.5K) or higher
• Communication LED label (Ethernet model and safety communication model): 1
Not used.
 How to read the SERIAL number
Rating plate example
Symbol Year Month Control number
SERIAL
14
1. Introduction
1.1 Product checking and accessories
Monitoring/protocol specifications
*1
Circuit board coating
Screw size (mm)
M3 × 35
The SERIAL consists of two symbols, three characters indicating the production year
and month, and six characters indicating the control number.
The last two digits of the production year are indicated as the Year, and the Month is
indicated by 1 to 9, X (October), Y (November), or Z (December).
Plated conductor
Without plated conductors
Without plated conductors
Quantity
1
Rated
Control logic
frequency
60 Hz Sink logic
50 Hz Source logic
60 Hz Sink logic
60 Hz Sink logic
50 Hz Source logic