Electrical Connection - Siemens SINAMICS S120 Manual

Motor connection, shield support and fabrication
4.1 Motor plug connector for Motor Modules 3 A ... 30 A
Note
Using identical plug connector variants for Double Motor Modules
Two connectors of identical type must be used on Double Motor Modules (both push-in
connectors or both connectors with screw terminals). It will not otherwise be possible to plug
them into the module.
The motor plug connectors 6SL3162-2M☐00-0AC0 as well as the motor plug connectors
used in the MOTION-CONNECT cable assemblies have been type-tested in combination
with the Motor Modules. Compliance with the stipulations made in the EC Declaration of
Conformity is only ensured in combination with these motor connection plugs.
The cULus approval has been granted for the motor plug connector system 6SL3162-
2M☐00-0AC0 as well as the motor plug connectors used in the MOTION-CONNECT cable
assemblies. Warranty for the technical function can only be ensured in combination with the
stated motor connection plugs.
Electric shock or fire caused by non-certified plug connectors in the power circuit
If non-certified plug connectors are used in the power circuit, this can result in overheating,
fire and/or electric shock.
• Only use approved plug connectors in the power circuit.
4.1.2

Electrical connection

The terminal assignments for individual cores at the motor connector are shown in the
following diagrams.
Connections for connector with push-in terminals
①
②
74
WARNING
Catch
BR+ (black)
Connections for connector with screw terminals
Power Units in Booksize C/D-Type Format
Manual, 12/2018, 6SL3097-5AC20-0BP0