Huawei OptiX RTN 980 Quick Installation Manual page 43

• Installation procedure
1
L1
A
Strip a part of the insulation layer B of the power
cable according to the cross -sectional area of the
conductor, and ensure that the conductor C of the
power cable is exposed for the length L1.
CAUTION
When stripping the insulation layer of a power cable, do not damage the metallic conductor of the power cable.
After the conductor is fed into the cord end terminal, the exposed part of the conductor of the power cable
cannot be more than 1 mm long.
3
H
W2
W1
3 Crimp the joint parts of the cord end terminal and the
conductor of the power cable based on a proper
cross-sectional area by using a crimping tool.
B
C
A
4
40
2
A
Route the conductor of the power cable into the cord
end terminal A, and then align the conductor with the
edge of the cord end terminal.
4
管状端子截面积
Cross-Sectional Area (mm 2 )
2
（mm ）
0.25
0.5
1.0
1.5
2.5
4
6
10
16
After crimping the terminal, check the maximum width of
the terminal, which needs to be less than the maximum
width specified in the table.
B
端子的最大压接宽度
Maximum Width (mm)
（mm）
1
1
1.5
1.5
2.4
3.1
4
5.3
6