Table of Contents
Advertisement
2.1.1.2 IP Address
To enable the device to communicate within the Ethernet network, you have to establish a network configura-
tion consisting of IP address, subnet mask and standard gateway.
The device is delivered with a default IP address that can be restored at any time by pressing the F4 softkey.
Each device also has a unique MAC address.
The default IP address and the default subnet mask are imprinted on the side panel:
Figure 2-1
Default IP Address and Softkey F4
The F4 softkey (see Figure 2-1) located on the right display side can be used to activate the factory-set default
IP address. When pressed (>3 s), this softkey activates the factory-set default IP address. After pressing the
softkey F4, the device restarts and the IP address and subnet mask are temporarily activated in the default
IP network configuration. The customer-specific IP configuration is not overwritten.
The network configuration settings can be displayed and edited via HTML pages or via the device display (see
Device Manual SICAM Q100 7KG95xx, order number E50417-H1040-C522). After a renewed restart the pa-
rameterized network configuration is used again.
SICAM Q100, 7KG95xx, System Manual
E50417-C1040-C522-A8, Edition 09.2020
Display Side with Softkey F4
2.1 Communication Interfaces
Softkey F4
Default IP Address:
192.168.0.55
Default Subnet Mask: 255.255.255.0
Communication
13
Hide quick links:
Advertisement
Table of Contents
