Advertisement
5
1. Cross fitting (1/4 inch
male)
2. Elbow (1/4 inch female x
1/4 inch female)
3. Adapter (1/4 inch male x
1/4 inch male)
15. Fasten the lift-control block assembly to the bracket
using 2 bolts (8 x 75 mm), 1 bolt (8 x 65 mm), 6 plain
washers (8 mm), and 3 locknuts (8 mm).
Note: Some of the solenoids may need to be loosened
or removed to gain access to the bolt holes.
1
3
3
5
1. Bolts (8 x 75 mm)
2. Locknut (8 mm)
3. Washers (8 mm)
16. Connect the lift hoses to their relevant connectors on
the lift control block.
Note: Some hoses will require arranging for neatness.
Where necessary, slacken the hose fittings at each end,
orientate to suit and ensure that both ends of the hose
fittings are tightened.
4
3
2
Figure 7
4. Bonded seal (1/4 inch)
5. Lift manifold
2
3
3
4
Figure 8
4. Bolt (8 x 65 mm)
5. Locknuts (8 mm)
1
1
G025513
g025513
1. Hose (1/4 inch x 2.16 m),
to the rotary valve at the
rear of the machine
2. Hose (existing), to the
front left lift cylinder
3. Hose (existing), to the
front right lift cylinder
4. Hose (existing), to the right
wing lift cylinder
17. Referring to
valve, and a solenoid. Fit the coupling, the bonded
seal, and the elbow to port 1 of the line body. Fit a
3/8 inch bonded seal, a 3/8 inch male x 3/8 inch
male adapter, two 3/8 inch bonded seals, check valve,
and 3/8 x 1/4 inch male adapter to port 2 of the line
body. Fit the assembly to the tee on the P port of the
lift control block. Fit the hose from the tee to the lift
G025408
pump. Fit the hose from the rotary valve at the rear of
the machine to the check valve.
Note: Ensure that the arrow on the check valve points
away from the line body.
g025408
6
2
8
7
Figure 9
5. Hose (existing), to the
center lift cylinder
6. Hose (existing), to the left
wing lift cylinder
7. Hose (existing), to the
front manifold
8. Hose (3/8 inch x 57.5 cm),
to the lift pump
Figure
10, assemble a line body, a solenoid
3
6
5
4
G025409
g025409
Advertisement
