Advertisement
Figure 10
Some fittings not shown
1. Solenoid
2. Solenoid valve
3. Line body
4. Bonded seal (3/8 inch)
5. Adapter (3/8 inch male x
3/8 inch male)
6. Check valve (3/8 inch)
18. Connect the electrical leads from the electric control
box to the relevant solenoids.
1
2
3
4
12
Figure 11
1. Right wing (labeled 2C)
2. Middle (labeled 2B)
3. Left wing (labeled 2A)
4. Lift override (labeled 3)
5. Labeled 2D
6. Labeled 2E
7. Adapter (1/4 inch male x
3/8 inch male)
8. Coupling (3/8 inch male x
3/8 inch female)
9. Elbow (3/8 inch male x 3/8
inch female), 90°
10. Tee (3/8 inch male x 3/8
inch female x 3/8 inch
male)
11. Lift manifold
5
5
6
7
6
7
8
9
10
1
2
3
4
7. Labeled 2F
8. Cutter reverse rotation
(labeled 1)
9. To the solenoid at the rear
of the machine
10. To the proximity sensor
11. Lift control block
12. Electric control box
2
Installing the Rotary Valve
Cylinder Assembly
Parts needed for this procedure:
1
Actuator bracket
1
Proximity sensor
1
Proximity-sensor bracket
g188311
2
Setscrew (6 x 25 mm)
4
Washer (6 mm)
2
Locknut (6 mm)
2
Cap screw (5 x 20 mm)
4
Washer (5 mm)
2
Locknut (5 mm)
1
Spacer
1
Solenoid valve (closed)
1
Line body
2
Bonded seal (3/8 inch)
1
Adapter (1/4 inch female x 3/8 inch male)
1
Bonded seal (1/4 inch)
1
Hose (1/4 inch x 380 mm), 90° x straight
1
Tee (1/4 inch male x 1/4 inch male x 1/4 inch female)
8
1
Adapter (1/4 inch male x 1/4 inch male), 1.4 mm orifice
1
Cylinder rod spring pin
1
Bush
1
Washer (10 mm)
1
Valve cylinder
1
Bonded seal (3/4 inch)
G025362
1
Adapter (1/4 inch male x 3/4 inch male)
1
Swivel tee (1/4 inch female)
1
Adapter (1/4 inch male x 1/4 inch male), 0.8 mm orifice
11
1
Hose (1/4 inch x 2.156 m)
g025362
1
Adapter (1/4 inch male x 3/8 inch male)
1
Split pin
8
Cable tie
1
Hose tie (368 x 4.8 mm)
Procedure
1. At the rear of the machine, remove the rear cover to
gain access to the rotary valve control system
12).
7
(Figure
Advertisement
