3-4-2 Installation method
Touch Screen Controller
Make space for installation and service.
Install the Touch Screen Controller in a wall (standard) or on the dedicated stand (when available on site).
In-wall installation
■ ■ ■ ■ ■ Conditions for installation
Space 30 mm or more between the controller and
surrounding objects as the ambient temperature
must satisfy the installation space requirements.
30 mm or more (rear)
Top view
30 mm or more (side)
Bottom view
For reference
Display stand (not supplied with the controller)
Use the CONTEC stand (model: IPC-SND-03).
For details of the stand, visit the CONTEC web site.
Europe: http://www.contec-europe.com/
China: http://www.contec.sh.cn/
REQUIREMENT
• Check that the installation dimensions on the rear of the
Touch Screen Controller equal the installation
dimensions of the CONTEC stand.
• Use the screws supplied with the stand to install the
controller.
Panel
30 mm or more (top)
30 mm or more (bottom)
Interface side
Panel
■ ■ ■ ■ ■ Attaching Fixture
■Panel cut size
+1
303
-0
R1 or less
Panel thickness: 1.6 -1.7 mm
1. Insert the controller from outside of the panel.
2. Insert the fixtures from inside of the panel.
The angle adjustment lock screw.
(Loosen the screw and adjust angle.)
38
REQUIREMENT
Use a panel
(procured on site) of
thickness 1.6-1.7 mm.
[mm]
Touch Screen
Controller
Panel
Fixture
Tightening screws excessively
may cause the screws to break.
Optimum tightening torque for
good waterproofing effect is
0.6N/m.