Error Messages; Alarm Display; Alarm Display When The Main Power Is Turned On - Sony DSR-2000A Service Manual

4-1. Alarm Display

This unit has an alarm display function.
When a problem is detected, an alarm is displayed immediately in the timer counter block. The alarm and a message
describing the countermeasure are displayed on a video monitor connected to the VIDEO OUT 3 (SUPER) or the SDI
OUTPUT 3 (SUPER) connector.
This unit has two types of alarms : one is for operators while the other is for service persons. This manual describes only
the alarms for service persons. For details of alarms for operators, refer to the operating instruction or overview in this
manual. Activating the alarm display may influence the system, such as when the reference video signal is not used.
Therefore, you can select whether or not to display the alarm from the Setup menu selection. As for Setup menu, refer to
Section 1 of this manual or to the operating instruction. However, the alarms for service persons are displayed regardless
of the Setup menu setting.
4-1-1. Alarm Display when the Main Power is
Turned On
Detection :
Operation after detection : None
Display :
Detection :
Operation after detection : The Setup menu operates
Display :
DSR-2000A/2000AP
Section 4

Error Messages

Checks the settings of switch
S201 on the SY-278 board and
the contents of non-volatile
memory (EEPROM).
The alarm is displayed until
any key is pressed.
Checks the version of the
Setup menu.
using the factory settings. The
contents of the non-volatile
memory (EEPROM) remain
unchanged. Therefore, if the
setting of the Setup menu is
not changed, the same alarm
will appear when the main
power is turned on.
The alarm is displayed until
any key is pressed.
ALARM
SETT I NG HAS BEEN
CHANGED TO
X1 ED I TOR NTSC (J)
CHECK THE S201 SW I TCH
ON THE SY BOARD.
ALARM
THE SETUP MENU SOFTWARE
HAS BEEN UPGRADED.
SET THE SETUP MENU I TEMS
TO THE DES I RED SETT I NGS
OR ACT I VATE THE ' LOAD
MENU DATA ' (MA I NTENANCE
MENU) FUNCT I ON.
4-1