CARD-PCI/GX Hardware Manual
A.4.5 CRT RGB signal
When noise is present on CRTR, CRTG or CRTB signal, display quality drops. To avoid
this make the wiring as short and far from other signals as possible so that no crosstalk
occurs.
A.4.6 Reset signal
Use the RST# signal for resetting the system (other than SCE8720C).
Do not make the signal wiring too long. If long wiring cannot be avoided, add a buffer or
a capacitor to remove noise.
Also, POWERGOOD signal should not be used to reset the system circuit (other than
SCE8720C). This is fine from the logical viewpoint, but it does raise the possibility to
extract noise, resulting in decreased liability.
78
EPSON
Rev.A