ABB ControlMaster CM15 Commissioning Instructions page 11

C O N T R O L M A S T E R C M 1 5 | U N I V E R S A L P R O C E S S I N D I C ATO R , 1/8 D I N | C I/C M 1 5 - E N R E V. A
Referring to Figure 4:
1 Position one panel clamp
against the panel.
2
Locate the panel clamp anchor
3 Tighten the panel clamp anchor screw
panel clamp A is lightly touching the panel
4 Repeat steps 1 to 3 to fit the remaining panel clamp
E
and panel clamp anchor
5 Torque tighten both panel clamp anchor screws to
0.1 N⋅m (0.9 lbf⋅in).
NOTICE
Do not over-tighten the screws.
A at the side of the case
B C
in slot .
D until
F
B
C
A
D
Figure 4 Panel clamp assembly
11
F
E