Toshiba BC Series Instruction Manual page 58

● Normal Shutter / TriggerMode = OFF
In this mode, the electronic shutter can be handled by the value in the register.
If shutter speed is longer than readout time, the frame rate changes according to shutter speed.
● Randum Trigger Shutter / TriggerMode = ON
An image is captured at the desired timing using trigger signal input.
External trigger (Hardware trigger) signal from CameraLink I/F (CC1) and software trigger from control
command are available (Fix mode). Operation point of HardwareTrigger is at the edge of trigger signal, and
active edge polarity is able to change by register setting (High active / Low active).
Note that Random Trigger Shutter will cause a delay between trigger signal and start of exposure.
- Fix mode (TriggerSequence0)
The exposure time is determined by Exposure Time setting.
PixelFormat
Mono8
Mono10/Mono12
* T1 and T3 are typical value
* T2 = electronic shutter setting value
Copyright © 2019 Toshiba Teli Corporation, All Rights Reserved.
TRIG
Exposure
FVAL
LVAL
DVAL
DATA OUT
T1
HighFramerateMode
OFF
ON
OFF/ON
T2 T3
T1 [μs]
ShortExposureMode
OFF ON
12.4 28.6
10.6 26.0
16.7 34.3
56 / 73
T3 [μs]
OFF ON
565.7 566.7
565.1 566.0
566.4 567.3
D4296087A
http://www.toshiba-teli.co.jp/en/