Operation; Intercom Ring Over Page; Programming - NEC DS1000 Release Notes

DS1000 02.10.09 Release Notes
Enhanced Features in 02.10.09

Operation

Intercom Ring Over Page

Programming

40 N 02.10.09
3. Dial the trunk you want to program + HOLD .
OR
Press Vol Up or Vol Dn to select the trunk you want to program + HOLD .
OR
Press HOLD to select trunk 1.
The previously programmed option for the selected trunk displays.
4. Select the type of ringing that will broadcast over the External Page (0=None, 1=Always,
2=Night only, 3=Delay only) + HOLD .
5. Go back to step 3 and select another trunk to program.
OR
Press CONF to exit program 0203.
When entering data, pressing:
G
Vol Up advances to next trunk.
G
Vol Down backs up to the previous trunk.
G
CHECK restores the previous entry.
G
HOLD registers the entry and advances to the next prompt.
G
CONF exists the program.
0401-Trunk Delay Ring
Use this option to set how long the system waits before ringing an extension that has the Delayed
Ringing option enabled. This option also sets the delay interval for delay ring trunks ringing the
external paging system. The default for this option is 10 (10 seconds).
To answer the call that is ringing over the Paging speakers:
1. Lift handset or press SPK .
2. Dial *0 .
3. Converse with the caller.
An extension's ringing can optionally broadcast over External Paging. If enabled, any type of call
that rings the extension will broadcast over the Paging speakers. While an Intercom call rings
External Paging, any extension user can dial a code ( ICM + *0 ) to pick up the call. If Door Box
chimes, ringing, and Background Music are all programmed to output over External Paging, the
system uses the following broadcast priority:
G
Paging
G
Door Box chimes
G
Ringing
G
Background Music
Note that External Paging can broadcast either extension ringing or trunk ringing, not both. In
addition, External Paging requires additional customer-provided equipment. Refer to the Hardware
Manual that came with your system for more.
0202-Page Ring Source
Use this option to assign an extension as the ring source for the External Page zone. By default, this
option is unassigned (none).
DS1000 Release Notes