4Terminal cover
This is used to avoid exposure of charged parts. Different kinds are prepared for
each application such as large size terminal cover (TC-L), small size terminal
cover (TC-S), transparent terminal cover (TTC), Rear terminal cover (BTC), and
plug-in terminal cover (PTC).
●
Quick set terminal cover
This cover can be attached simply by inserting into the mount hole on the circuit
breaker proper.
To disengage, slip off the cover stop projection by a finger or a screwdriver, then
pull out. (PTC is of screw fix type.)
❈ The models of NF125-SGW/HGW/RGW/UGW, NF160-SGW/HGW, NF250-
SGW/HGW/RGW/UGW are excluded.
NF125-SGW/HGW/RGW/UGW, NF160-SGW/HGW,
NF250-SGW/HGW/RGW/UGW
DSN125-SGW, DSN160-SGW, DSN250-SGW
Mounting
1) Put the U-form projection in the hole of the breaker and push
the terminal cover strongly to fasten it.
(Push the indicated place by the "
2) Fix the terminal cover with tapping screws (in 4 positions
with tightening torque 0.6 – 0.8 N·m).
Removing
1) Remove the tapping screws.
2) Push the tip of the U-form projection fully toward the "
mark by the screw driver or a finger tip and pull out the ter-
minal cover toward the "
" mark.(Note)
When a small size terminal cover (TC-S) is used, cover up the conducting part of the ring-type terminal with insulation tube or by taping but not
exceeding surface A.
Circuit breaker
Ring-type terminal
L
Bus bar
L
" mark.)(Note)
"
Note. No insulation barriers are needed with terminal covers are attached.
Terminal cover
A
B
TC-L & TTC
lnsulator
TC-S
Tapping screw (2pcs.)
Enlarged
view of
U-form projection
(Note)
TCL-2GSW3
Note. except BTC or PTC
Small size terminal cover
Surface A
lnsulation tube
Exposed live parts
Limited condition
(mm)
NF30-CS, MB30-CS,
NV30-CS
NF32-SW,
50A frame, 63A frame
NF125-SGW/HGW
NF160-SGW/HGW
NF250-SGW/HGW
NF125-UGW/RGW
NF250-UGW/RGW
other 125A frame
other 160A frame,
250A frame
topper
projection
Quick-set terminal
cover
Mount hole
Tapping screw
Enlarged
view of
U-form projection
TCS-2GSW3
Wire
TC-L & TTC
A
B
L
A
25
34.5
29.5
5
25
34.5
29.5
4.1
40
50.5
45.5
3.5
40
50.5
45.5
4.5
40
50.5
45.5
3.2
(Note)
TC-S
B
L
14.5
12.0
13.5
11.0
14.0
11.0
15.0
12.5
13.5
11.0
34