Panasonic SF2B Series Quick Instruction Manual page 44

<Mounting of the bottom cap cable (optional)>
● Do not lose any screws during extension / dismantling.
● The bottom cap cables are distinguished with the color of the connectors, the color of
the connector for emitter is gray and that of the receiver is black. Connect the cable to
emitter and receiver without fail using their colors as the guide.
● The packing is attached to the connector of the bottom cap cable..If the packing is not
attached correctly, reattach the packing as shown in the figure below, and mount to this
device.
1. Insert the connector of the bottom cap cable (optional) into the connector of this device.
When inserting the connector, fit the cable to the groove of this device.
2. Tighten the two M3 screws. The tightening torque should be 0.3N·m or less.
44
CAUTION
Bottom cap cable (Optional)
Connector
Cable
Connector
Groove
M3 screw
Enclosed with the
bottom cap cable
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
This device