Copying Menu Settings Between Projectors - Epson LightScene EV-110 User Manual

7. Select the Combination setting, and then select one of the following options:
• None to always start the operation set in GPI-1 Settings regardless of the GPI-2 signal.
• GPI-2 Low to start the operation set in GPI-1 Settings when the GPI-2 signal falls below a certain
voltage.
• GPI-2 High to start the operation set in GPI-1 Settings when the GPI-2 signal exceeds a certain
voltage.
Note: You can check the current value for the GPI-1 and GPI-2 signals in the GPI Info. menu from
DC Out (2.0A)/GPI In Settings.
8. Select the High -> Low setting, if necessary.
9. If you need to add a certain amount of time until the selected operation is executed, select Hold
High or Hold Low.
When the sensor signal is maintained continuously for the set time, the operation is executed.
Note: You can select from 0 seconds to 30 minutes for the Hold High and Hold Low settings.
10. Press Esc to return to the previous screen, and then select the GPI-2 Settings option if necessary.
11. When you are finished, press Menu to exit the menus.
Parent topic:
Related tasks
Connecting to External Sensor Devices

Copying Menu Settings Between Projectors

After you select menu settings for your projector, you can transfer them to another projector of the same
model.
Note: Copy the projector's settings before you adjust the projected image using the projector's image
adjustment settings. Any saved User's Logo setting on the projector will transfer to the other projector.
Caution: If the copy process fails due to a power failure, communication error, or for any other reason,
Epson will not be responsible for any repair costs incurred.
Adjusting Projector Features
131