You see this screen:
2. Set the Overlay Effect setting to On.
3. Select Lightness and press
4. Use the left and right arrow buttons to lighten or darken the effect.
5. Press Menu to exit.
Parent topic:
Projection Modes
Depending on how you positioned the projector, you may need to change the projection mode so your
images project correctly.
• Front (default setting) lets you project from a table in front of the screen.
• Front/Ceiling flips the image over top-to-bottom to project upside-down from a ceiling or wall mount.
• Rear flips the image horizontally to project from behind a translucent screen.
• Rear/Ceiling flips the image over top-to-bottom and horizontally to project from the ceiling and behind
a translucent screen.
Note: You can change the projection mode using the remote control or by changing the Projection
setting in the Extended menu.
Changing the Projection Mode Using the Remote Control
Changing the Projection Mode Using the Menus
Parent topic:
Related references
Projector Setup and Installation Options
Enter.
Overlay Effects and Shape Filters
Using Basic Projector Features
98