Adjusting The Image Position - Epson LightScene EV-110 User Manual

Adjusting the Image Position

You can use the Image Shift feature to adjust the image position without moving the projector.
Note: This feature is not available if the digital zoom is set to the widest setting.
1. Turn on the projector and display an image.
2. Adjust the image size using the Zoom buttons on the remote control.
Note: When the projector uses optical zoom, you need to switch to digital zoom by reducing the size
of the image until a message is displayed.
3. Press
4. Use the arrow buttons on the remote control to adjust the image position.
Note: You can shift the image diagonally by pressing any pair of adjacent arrow buttons on the
remote control.
5. Press Esc to close the Image Shift screen. The screen closes if no operation is performed for
approximately 10 seconds.
Note: The Image Shift setting is retained even if the projector is turned off; however, you need to
readjust the image position if you change the projector's location or angle.
Parent topic:
Enter to display the Image Shift screen.
Using Basic Projector Features
87