Commissioning Prerequisites - Huawei BTS3900 GSM Commissioning Manual

BTS3900(A) GSM
Commissioning Guide
Tools
Serial port cable
Flat-head screwdriver
Light emitting diode (LED)
Information About the Base Station
Before the commissioning, you must obtain the following information about the base station:
l
l
Board Software
When the transmission is unavailable, download the matching software for the boards to the
SMT PC before the commissioning.
The software for the boards in the BTS3900/BTS3900A is as follows:
l
l
l
l

2.2 Commissioning Prerequisites

Before the commissioning, you must check the operating status of the BTS3900/BTS3900A and
BSC.
Hardware Requirements
l
l
Issue 02 (2009-04-20)
Information on BTS networking and related configuration, including the BTS type,
transmission mode, networking mode, and cell configuration.
BTS3900/BTS3900A data configured on the BSC side.
RFU software
GTMU software
GATM software
PMU software
The BTS3900/BTS3900A cabinet is installed and the cables are connected.
The BTS3900/BTS3900A has passed the hardware installation check before it is powered
on.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 General Requirements for the Commissioning
Qua Specification
ntity
1 Optional. The serial port cable is used when you
query the IP address of the board on the BTS side.
The auxiliary cables are listed as follows:
One commissioning cable connected to the serial
l
Ethernet port
One extended serial port cable
l
1 Optional. The flat-head screwdriver is used to
remove the Ethernet cable when the transmission
between the BSC and the BTS is unavailable.
When removing the Ethernet port, you must use a
flat-head screwdriver to press the RJ45 connector
and then remove the RJ45 connector.
2 Optional. The LEDs are used to determine the RX or
TX end of the E1 line.
2-3