Table of Contents
Advertisement
Figure 27
4.
At the right side of machine, loosen 2 capscrews
that secure slider-frame rail to the right fender
(Figure
28). Ensure that the capscrews are
loose enough to allow slider bed tip.
Figure 28
1. Capscrews (slider-frame rail)
5.
At the left side of machine, remove 2 capscrews
and 2 washers that secure slider-frame rail to
the left fender
(Figure
g012669
g012670
29).
1. Lifting rod
Removing the Belt
Cut belt and remove it from rollers.
Installing the Belt
1.
Insert a lift bar though the hole at the left
slider-frame rail, and raise the lift bar to tip frame
rail slightly; refer to
the Slider Bed (page
2.
Assemble the belt over the lift bar and rollers
as far as possible.
3.
Insert a plastic belt tool between each roller and
the belt.
Rotate rollers until each tool is positioned to the
outside of each roller. Insert the tool past rib in
the center of belt.
4.
Slide belt and belt tools further onto rollers until
belt is centered on rollers.
5.
Remove belt tools.
6.
Align belt so that the belt rib fits into alignment
grooves in each roller.
25
Figure 29
2. Capscrews (slider-frame
rail)
Figure 29
in
Disassembling
24).
g012671
Advertisement
Table of Contents
