Product Overview; Controls - Toro Topdresser 2500 Operator's Manual

Product Overview

Controls

Gate Metering Control
1. Adjusting handle
2. Gate-lock knob
The gate-lock knob and adjusting handle are located
at the left rear side of machine, and are used to adjust
and lock the gate into the desired open height position
(Figure 9).
1. Loosen the adjusting gate-lock knob enough to
allow gate and knob to slide freely in slot.
2. Move the adjusting handle to set the gate into
the desired position, and tighten the gate-lock
knob secure the gate.
Figure 9
3. Rate scale
Hand Control Switch
Press hand control switch to start or stop the flow of
material from topdresser
g266287
1. Hand control switch
11
(Figure 10).
Figure 10
g269331