Toshiba IPedge Manual page 17

PC Attendant
Pooled Line Button
Privacy/Non-privacy
Private Networking Over IP
Release Button
Release/Answer Button
SIP Extension
© 2011 Toshiba Information Systems, Inc. All Rights Reserved. All product, service and company names are trademarks, registered trademarks or
service marks of their respective owners. This document and the information included herein is subject to change without notice.
The Network DN cannot be specified as the Park-to destination in remote
Park.
The Attendant in Attendant Mode cannot be parked becuase it cannot be
consultation held by the station except Attendant.
The Pool button indicates "Idle" when a trunk call is parked by the Call
Park Orbits feature. However, "In-Use" is indicated if all lines assigned to
the Pooled Line button are busy.
Pressing the secondary appearance button to barge into the call is
ignored when the secondary appearance button indicates "In-Use," even
if the Privacy/Non-privacy setting is enable to barge in.
Pressing the Privacy Release button by the parking party or the parked
party is ignored.
The Privacy Release is finished when the call is parked.
When a call is parked by Call Park while speaking, the call is parked at
the node of the extension that activates Call Park. It is not supported to
park the call at remote nodes through a tie line.
It is possible to answer the call parked from the remote node. To operate
this, dial the Network Feature Access Code and the Orbit number. The
Network directory number is accepted as the orbit number, but if a node
ID different from the Network Feature Acces Code is specified, an error
occurs. Note that only the DN can be prefixed with Node ID. The system
orbit number cannot be prefixed with Node ID.
Pressing the Release button while entering an Orbit number for the
parking feature access code disconnects and releases the call. Then
Consultation Hold recall terminates.
Pressing the Release/Answer button while entering the Orbit number for
the parking feature access code disconnects and releases the call, then
terminates the incoming call on the station.
The SIP station can put the far end party on consultation hold and invoke
the park feature by entering the feature access code. However, Automatic
Park cannot be performed from SIP station.
The Secondary Dial tone is not connected after Park registration. It is just
disconnected. (Park and Page cannot be performed.)
It is possible to retrieve a parked call.
IPedge / VIPedge Feature Desc. 7/25/12
1-3