Creating A Team - Fujitsu PRIMERGY PG-LND101 User Manual

5.2

Creating a Team

Perform the following procedures to create a team.
1
Log on with the administrator privileges.
2
Click [Start] → [Settings] → [Control Panel] → [Intel®PROSet
Wired], and start Intel
3
Select a LAN adapter to build in the team, and right click.
4
Click [Add to Team] → [Create New Team...].
The [Teaming wizard] window appears.
5
Select a Teaming type with which you want to create a Team.
• AFT type: "Adapter fault tolerance"
• ALB type: "Adaptive load balancing"
• SFT type: "Switch fault tolerance"
Do not select other types of team.
6
Click [Next].
7
Select LAN adapter to build in the team, and click [Next].
8
Click [Finish].
9
Click [OK] and exit Intel
When the teaming setting is completed, a virtual adapter "Intel(R) Advanced Network
Services Virtual Adapter" appears.
Upper layer protocol is bound to this virtual adapter.
You cannot bind them with the Ethernet controller that makes up a Team.
The IP address is set in this virtual adapter.
10
Restart the system.
68
®
PROSet.
®
PROSet.