Enabling Bass Amplification; Selecting A Station; Automatic Station Search And Automatic Store - Silvercrest SWDR 500 B1 Operating Instructions And Safety Instructions

SilverCrest SWDR 500 B1

9.13 Enabling bass amplification

You can choose to have the bass sounds amplified.
 While the device is powered on, press the "SNOOZE/BASS" button (2).
BASS (31) is shown on the display (6).
 Press the "SNOOZE/BASS" button (2) again to disable bass amplification.
The "BASS" indicator (31) goes out.

9.14 Selecting a station

For an optimum reception, please fully extend the telescopic antenna (1)
before tuning a station. The telescopic antenna (1) can be rotated. This lets you
optimise the signal quality.

9.15 Automatic station search and automatic store

The most convenient way to search for and store radio stations is the automatic
scan with auto-store.
 Power the device on.
 Press the "BAND" button (7) to select the desired frequency band.
 Keep the "SET/STORE" button (9) pressed for approx. 1 second to launch
the automatic station search. The automatic station search always starts at
the lowest frequency.
 The multi-band tuner (A) will scan the entire frequency band for strong radio
stations.
 The 100 first found stations are directly saved on the presets P001 to P100.
After all 100 presets have been filled, the station search continues to the end of
the frequency band but no more stations will be saved. After the scan is
finished, the station of preset P001 will be tuned-in.
Please note that any station presets already used will be
overwritten.
70 - English